ShearSharp is an amazing device designed
to take the mystery out of sharpening your
general-purpose scissors, hedge clippers
and tin snips.

1589600027

 

ShearSharp® Scissor Sharpener
ShearSharp is an amazing device designed to take the mystery out of sharpening your
general-purpose scissors, hedge clippers and tin snips. The large ergonomic handle fits either
hand safely and securely. The full-length finger guard protects your fingers. Sharpening blades
are Diamond Honed Tungsten Carbide and provide years of reliable use.
ShearSharp will not rust and can be cleaned with soap and water, or in the dishwasher. If you
own a pair of scissors, you will want to have the easy-to-use, affordable ShearSharp Scissor
Sharpener.
VERY LIGHT DOWNWARD PRESSURE WILL GIVE YOU THE SHARPEST CDGE.
PLEASE NOTE: Tilt SHEARSHARP slightly to the side until the carbide blade rests flat
against the top edge of the scissor blade being sharpened.
ShearSharp™ is an amazing device designed to take the mystery out of sharpening general
purpose scissors, hedge clippers, tin snips and the like, and it works equally well for right or
left handed people. To use, hold shears and ShearSharp™ as shown in the illustration. Using
very light downward pressure, draw ShearSharp™ past the point of the blade. ShearSharp™'s
tungsten carbide blade will do the rest. Approximately 2 or 3 passes in this manner on each
blade should be sufficient to return your shears to "new" sharpness. More passes may be
required on extremely dull blades.
REMEMBER: THE SHARPENER MOVES
WHILE THE TOOL BEING SHARPENED REMAINS STATIONERY.
The tungsten carbide blade of ShearSharp™ is of high grade industrial quality and one of the
hardest materials known. Even so, after several years of use, it may become worn. Due to its
unique design the sharpener can be reversed for double life.
To reverse the sharpener blade lay the ShearSharp™1
on its side with the screws up. Remove the screws and carefully separate the two halves of
the handle as shown in the illustration at right. ,
Simply flip the tungsten
carbide sharpener blade over
as illustrated. CAUTION: DO NOT
REASSEMBLE S/)earStop™WITHOUT
THE FINGER GUARD. SERIOUS INJURY
MAY RESULT. DO NOT OVER TIGHTEN SCREWS.
The factory torque setting is about 5 inch pounds of pressure.
Tighten them only until you feel increased resistance. If sharpener has any cracks
around the screw heads-do not use it. Either discard the sharpener or return it under
the terms of the warranty.
ShearSharp™ is not recommended for pinking shears, high quality barber, beautician,
dressmaker or similar shears. These should be sharpened
by a professional sharpening service. ShearSharp™ is perfectly safe when used properly. As
a precaution, the sheaf's blade should be thoroughly cleaned after sharpening.